/* Light YouTube Embeds by @labnol */

  Home > Products > Gaskets, Seals & Small Parts > Small Parts > Crush Sleeves >

Short Pinion Nitro Crush Sleeve, 2017+ Ford Superduty for Dana 60
Dana 60 Short Pinion Nitro Crush Sleeve


 
Price: $8.39


Product Code: DANCS-2
Qty:

Description Vehicle Applications Warranty Information
 

Nitro Gear & Axle
Short Pinion Crush Sleeve for Dana 60

Fits:
2017+ Ford F250 Superduty (front)
2017+ Ford F350 Superduty (front)
2017+ Ford F450 Superduty (front)


Nitro Gear & Axle strives to provide the highest quality differential components available. We take the steps necessary to ensure our parts are dependable. Our product range is continually growing to meet the needs of consumers for new ratios and Fits. At Nitro, we know differentials and know what it takes to provide you with high-quality components.

Nitro Gear and Axle Premium Differential Ring and Pinion Gears, Axles and parts


The Dana 60 Trademark referred to herein is a trademark of Dana Limited. The Dana 60 Trademarks is used for informational purposes only, and there is no connection between Nitro Gear & Axle or JT's Parts & Accessories and Dana .

WARNING:

This product can expose you to chemicals including toluene and benzene, which are known to the State of California to cause cancer and birth defects or other reproductive harm.
For more information go to: www.P65Warnings.ca.gov

WARNING:

This product can expose you to chemicals including toluene and benzene, which are known to the State of California to cause cancer and birth defects or other reproductive harm.
For more information go to: www.P65Warnings.ca.gov

B1189

WARNING:

This product can expose you to chemicals including toluene and benzene, which are known to the State of California to cause cancer and birth defects or other reproductive harm.
For more information go to: www.P65Warnings.ca.gov

Average Rating: Average Rating: 1 of 5 1 of 5 Total Reviews: 1 Write a review »


  0 of 0 people found the following review helpful:
 
1 of 5 not what I needed December 9, 2020
Reviewer: Fred Tanner from Layton, UT United States  
I had no problem with your service, but I do Have one with your disregard of my email just sending me to the reviews
****MY EMAIL ASKED******
I m looking for the crush sleeve from the Nitro master install kit MKD60-F. I
ordered the DANCS-2 (Order#: 163233) and they are too big. The one I need has a
1.25" inner diameter
Can you help
Fred Tanner
fav5fredy@netzero.com
801-791-2939

Was this review helpful to you?


Browse for more products in the same category as this item:

Products > Gaskets, Seals & Small Parts > Small Parts > Crush Sleeves